控制中心空調解決方案

 恒溫恒濕空調    |      2016-04-06
針對控制中心的空調解決方案刊殉，控制中心的特點為監控設備的即時動態，設備放置室有大量發熱設備低千，控制中心內人員不會太多配阵。根據控制中心的特點，空調選型推薦如下：HIMOD S13機型示血。
This is a solution of A/C for a control room. The characteristic of the control room is the workplace for real-time monitoring, and there is a large amount of equipment in an equipment room. Production personnel are not too much. According to the characteristics for the control room, the selection of model is recommended as HIMOD S13.
經濟效益評估：(Economic Evaluation)
  • 該控制中心需安裝空調面積總計100平方米左右棋傍，有大量發熱設備，對溫濕控制及節能有要求难审，依據實際情況每平米所需制冷量平均按350W計算瘫拣，總需求的35KW制冷量。
The total area is of about 100 square meters for the control room, and there is a large amount of heat source, and it requires the temperature and humidity control and energy saving features. Required cooling capacity per square meter on average calculated based on the actual situation according to 350W, the total demand for cooling capacity is of 35KW.
  • 要滿足該項目35KW的制冷量告喊，需使用HIMOD S13機組3套裝機麸拄。
To meet the cooling capacity of 35KW, this project is needed to use three sets of units (HIMOD S013 x 3).
  • 經濟效益對比估算：傳統空調滿足35KW制冷量的輸入功率至少為12KW左右，而HIMOD S13機組3套主機的輸入功率合計為7.6KW惯慎，主機部分省電36.6%颤皆，全年共計節省電費0.84萬元以上。(按1年運行8個月灯忙，1月運行30天给番，1天運行8小時，用電按1元1度計算)
Comparison of economic benefit estimation: the traditional air-conditioning input power (35KW cooling capacity) is at least about 12KW and the input power for HIMOD S13 (x3) is of 7.6KW. The energy saving is up to 38.6%. The annual saving is more than 8400 CNY. (According to 8 months per year, 30 days per month, 8 hours per day of operation, electricity by 1 CNY/1 degree calculation)